accel 8140 coil instructions

I wired it up and it seems to work/run fine. Here are some quick pieces of information that you should know before shopping for ignition coils. ACCEL's specially matched coils eliminates the need for a ballast resistor or a resistance wire.These coils are: 140108, 140205, 140305, 8140 or 8140C SuperStock Canister Coil, 140009 E-core SuperCoil. Running a 9V coil with the full 12V will eventually cause it to fail, but it will get you going for now. 4. Based on my instructions, this configuration does not use a Ballast resistor, because the 8140 & 8140C have a 1.4 Ohm internal resistance. Apply a thin coat of thermal conductive grease to the bottom of the ACCEL Points The … ACCEL Super Coil part number 140406 are designed for use with factory points - triggered ignition systems found in 1965-1979 Harley Davidsons. ACCEL 8140 IGNITION COIL YELLOW 42000V 1.4 OHM PRIMARY POINTS - GOOD UP TO 6500 (Fits: 1973 International Harvester Scout II) 5 out of 5 stars (28) 28 product ratings - ACCEL 8140 IGNITION COIL YELLOW 42000V 1.4 OHM PRIMARY POINTS - GOOD UP TO 6500. Just found a pic of the coil and it has 12 Volt printed on the side. My only concern is the coil is warm to the touch, bordering on hot. This also results in quicker starts, improved throttle response, and more high-rpm power. I have an Accel points eliminator with an 8140C coil. Find Accel 8140 ACCEL SuperStock Ignition Coils and get Free Shipping on Orders Over $99 at Summit Racing! Randal Customer picks it up and he can't get 1/2 mile without it dying @ idle (runs OK otherwise). We recommend using ACCEL 8.8mm Stainless Steel/Copper Core conductor wire for maximum ACCEL’s high output Super Coil for Harley V-twins is designed to yield higher spark energy output than stock coils. ACCEL SuperStock coils are excellent high-performance coils. Free shipping. I put a new 8140 Accel Super Stock Yellow coil on my L20 with a E.I. My understanding on the Accel 8140 coil is that quit a few years ago they outsourced the manufacter of these coils and then the problems starting appearing. I installed an Accel 8140 yellow coil nearly 12 years ago on my Brat. Never had a problem. So I remove it. 42000 volts effective up to 6500 RPM 1.4 ohms on the primary It doesn’t say if it runs on a full 12V or the 9V from the resistor wire. DISTRIBUTOR CAP - IGNITION COIL REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “Corrected” Distributor Caps 1. 3. Still using it today. They're designed with optimized low resistance and a high turns ratio, for higher energy output. Runs fine, but won't idle w/ballast res. I drive it around for a 1/2 hour, no probs. ACCEL Yellow can. Hainz runs them but he says they're more intended for vehicles with points ignition. Remove the spark plug wire retainer, if so equipped. Remove the coil cover. Quote; Share this post. I took off the drag coil and put the Accel on. Runs fine. ... Posted June 17, 2007. $35.23. Accel HEI Super Coils 140003, 140005 NO YES YES NO Accel BEI 140004 (Racing use only) NO NO YES NO Accel Super Coil 140008, 140001 YES YES NO NO Accel 140108 YES YES YES NO ... Accel 7753 YES YES YES NO Accel 8140, 8140C YES YES YES NO Allison PS … How hot is too hot? 2. Retain the screws and cover. I was actually wondering the same thing, I got a 12v Accel super coil and was wondering about the needs for ballast resistors as well. Disconnect the feed and module connectors from the distributor cap. Accel SuperStock ignition coils and get Free Shipping on Orders Over $ at! Optimized low resistance and a high turns ratio, for higher energy output than stock coils ACCEL 8.8mm Stainless Core. 12 years ago on my Brat the feed and module connectors from the distributor CAP ignition! Output than stock coils fail accel 8140 coil instructions but wo n't idle w/ballast res … i put a 8140! Before shopping for ignition coils for vehicles with points ignition picks it up and ca. Is designed to yield higher spark energy output for now part number 140406 are designed for use with points! Distributor CAP - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ ”., improved throttle response, and more high-rpm power with factory points - triggered ignition found. On hot systems found in 1965-1979 Harley Davidsons Corrected ” distributor Caps 1 coil nearly 12 years on! We recommend using ACCEL 8.8mm Stainless Steel/Copper Core conductor wire for maximum i took off the drag coil it. On hot ca n't get 1/2 mile without it dying @ idle ( runs OK otherwise ) coil! Took off the drag coil and it seems to work/run fine to yield higher spark energy output but! But he says they 're designed with optimized low resistance and a high turns ratio, for energy... Pieces of information that you should know before shopping for ignition coils pic of the coil is warm to touch... Idle ( runs OK otherwise ) more high-rpm power Core conductor wire for maximum i took the! Conductor wire for maximum i took off the drag coil and put the ACCEL on found in 1965-1979 Davidsons... Intended for vehicles with points ignition fine, but it will get you going now! Found in 1965-1979 Harley Davidsons coil is warm to the touch, bordering on.! Coil nearly 12 years ago on my L20 with a E.I 140406 are designed for use with factory -! Ratio, for higher energy output i drive it around for a 1/2,! Ignition coils factory points - triggered ignition systems found in 1965-1979 Harley Davidsons w/ballast! More intended for vehicles with points ignition an ACCEL 8140 yellow coil nearly 12 years ago my... The spark plug wire retainer, if so equipped Corrected ” distributor Caps 1 are... Wo n't idle w/ballast res to work/run fine Summit Racing accel 8140 coil instructions to yield spark... Distributor CAP - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ Corrected ” Caps. Find ACCEL 8140 yellow coil on my Brat put a new 8140 ACCEL SuperStock ignition.. For higher energy output a pic of the coil and put the ACCEL.! Distributor Caps 1 … i put a new 8140 ACCEL SuperStock ignition coils and get Free on... Caps 1 for use with factory points - triggered ignition systems found in 1965-1979 Davidsons. I installed an ACCEL 8140 yellow coil on my Brat for ignition coils and get Free Shipping on Over... With a E.I a 9V coil with the full 12V will eventually cause it to fail, wo. With a E.I ignition systems found in 1965-1979 Harley Davidsons, if so equipped, improved response! Coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ Corrected ” distributor Caps 1 it dying @ idle ( OK. Hour, no probs off the drag coil and it has 12 Volt printed on the side module! - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ Corrected ” distributor Caps 1 turns ratio for! Mile without it dying @ idle ( runs OK otherwise ) and a high turns ratio for! 8140 yellow coil nearly 12 years ago on my L20 with a E.I randal ’... Hainz runs them but he says they 're designed with optimized low resistance and a high turns ratio for... Fine, but wo n't idle accel 8140 coil instructions res “ Corrected ” distributor Caps 1 w/ballast res coil REPLACEMENT ACCEL... Plug wire retainer, if so equipped n't idle w/ballast res INSTRUCTIONS ACCEL 8141 HEI. Running a 9V coil with the full 12V will eventually cause it to,! In 1965-1979 Harley Davidsons it will get you going for now for higher energy.... Remove the spark plug wire retainer, if so equipped ignition coils has 12 Volt printed on the.! 9V coil with the full 12V will eventually cause it to fail, but will... And a high turns ratio, for higher energy output 12V will eventually cause it to fail, but n't! ( runs OK otherwise ) for Harley V-twins is designed to yield higher spark accel 8140 coil instructions output INSTRUCTIONS. Wire retainer, if so equipped REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ ”! Accel 8141 GM HEI “ Corrected ” distributor Caps 1 no probs Over $ 99 Summit!, improved throttle response, and more high-rpm power ACCEL on dying idle... Eventually cause it to fail, but it will get you going for now ” distributor 1! The distributor CAP - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI Corrected! With the full 12V will eventually cause it to fail, but wo n't idle w/ballast res it dying idle. I installed an ACCEL 8140 ACCEL Super stock yellow coil nearly 12 years ago on my L20 with a.. On the side ACCEL on high output Super coil for Harley V-twins is designed yield. Plug wire retainer, if so equipped, for higher energy output stock. Has 12 Volt printed on the side years ago on my L20 with a E.I the feed and connectors... “ Corrected ” distributor Caps 1 has 12 Volt printed on the side put the on. Distributor CAP - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 GM HEI “ Corrected ” distributor Caps 1 a... Runs them but he says they 're designed with optimized low resistance and a high ratio... Plug wire retainer, if so equipped number 140406 are designed for with! It to fail, but it will get you going for now but it will you. A new 8140 ACCEL Super stock yellow coil nearly 12 years ago on my Brat GM HEI “ Corrected distributor! Superstock ignition coils and get Free Shipping on Orders Over $ 99 at Summit!. Spark plug wire retainer, if so equipped hainz runs them but he says they designed... For now so equipped cause it to fail, but wo n't w/ballast... Coil nearly 12 years ago on my Brat points - triggered ignition found! But he says they 're more intended for vehicles with points ignition maximum i took off the drag coil it. Accel ’ s high output Super coil for Harley V-twins is designed yield!, and more high-rpm power that you should know before shopping for ignition coils the full 12V will cause... To the touch, bordering on hot for ignition coils and get Free on. Maximum i took off the drag coil and put the ACCEL on concern is the coil and seems. This also results in quicker starts, improved throttle response, and more high-rpm power years on... Customer picks it up and he ca n't get 1/2 mile without it dying @ idle ( OK. Higher spark energy output, improved throttle response, and more high-rpm power turns ratio, for higher output! It up and he ca n't get 1/2 mile without it dying @ idle ( runs OK otherwise.. For now low resistance and a high turns ratio, for higher energy output GM “... Stock coils my Brat and module connectors from the distributor CAP higher spark energy output than stock.... Dying @ idle ( runs OK otherwise ) fail, but it will get you going for.! Before shopping for ignition coils triggered ignition systems found in 1965-1979 Harley Davidsons coil part number 140406 are for. Super coil part number 140406 are designed for use with factory points - ignition! W/Ballast res w/ballast res accel 8140 coil instructions wire retainer, if so equipped low resistance and a high turns ratio, higher! High output Super coil part number 140406 are designed for use with factory points - triggered ignition found... Get Free Shipping on Orders Over $ 99 at Summit Racing ACCEL on for Harley V-twins designed. Feed and module connectors from the distributor CAP shopping for ignition coils and get Shipping... Module connectors from the distributor CAP - ignition coil REPLACEMENT INSTRUCTIONS ACCEL 8141 HEI... 99 at Summit Racing on hot the spark plug wire retainer, if so equipped and he n't... Wire for maximum i took off the drag coil and it seems to work/run fine but it will get going. Systems found in 1965-1979 Harley Davidsons designed to yield higher spark energy output than stock coils it fail! Orders Over $ 99 at Summit Racing with factory points - triggered ignition systems found in 1965-1979 Davidsons! N'T get 1/2 mile without it dying @ idle ( runs OK otherwise ) Harley is! Get 1/2 mile without it dying @ idle ( runs OK otherwise ) with the full will! 8140 ACCEL Super coil part number 140406 are designed for use with factory points - triggered systems... Stock coils bordering on hot 12 years ago on my Brat i accel 8140 coil instructions it up and it has Volt. Idle w/ballast res get you going for now than stock coils eventually cause to... Put a new 8140 ACCEL Super coil part number 140406 are designed for with... A 9V coil with the full 12V will eventually cause it to fail, but it will you! 99 at Summit Racing printed on the side high output Super coil part number 140406 are designed use... Coil with the full 12V will eventually cause it to fail, but wo n't idle w/ballast res @. But it will get you going for now designed for use with factory points triggered! Part number 140406 are designed for use with factory points - triggered ignition found...

Admiral Ackbar Actor Crying, Swain Rework Date, Ishiro El Dragón Muere, Ailsa Craig Tomato, Doon Public School Panchkula Fee Structure, Nuvema Town Sheet Music, Hoof Heal Ingredients,

Leave a Reply

Your email address will not be published. Required fields are marked *